Spring Car maintenance Guide First, check the engine oil The vehicle is parked
on a level surface. Unplug vernier check the oil quantity, if in the (F) and (L)
is two standard lines belong to the normal range, if less than (L). You should
add the specified models oil, after liquid fuel can't be higher than (F).
Second, check the engine coolant level When the engine warm-up state launch
cresetter, don't open the radiator cap, otherwise you might be burned by
spilled coolant or high temperature steam. Such as the engine cooling, check the
coolant level should be between full and low bit, or should add distilled water
or purified water (not mineral water plus) or frozen liquid, liquid level water
does not exceed the full bit. If found cooling liquid decrease rapidly in a
short time, should be checked the cooling system whether leaks or go to service
station to repair. Third, the braking surface inspection If the brake fluid is
close to the lower limit or below the lower limit means that the system may have
a leak or excessive brake shoe wear should be timely maintenance to the service
station. Additional brake fluid, we should pay attention to add the same type of
brake fluid launch
x431 pro, to prevent damage to the cup, attention to protecting the paint to
prevent corrosion paint. Fourth, the clutch master cylinder surface inspection
Clutch level between high and low level between said normal, if less than the
standard line, it may be damaged master cylinder or wheel cylinder cup. The
engine operating status appears difficult or impossible to hang hanging file
behavior, to the nearest service station immediate overhaul. Fifth, the battery
maintenance checks Check the battery is firmly fixed electrolyte should be
between the upper and lower limits, close off the assembly line should be timely
additional electrolyte or distilled water to the high line. Positive and
negative battery cables to keep good contact, and keep the battery clean and
dry. Place a long time to take off the positive and negative vehicle battery
cables, separated by about half rewired about 20 minutes after starting the
engine, if the battery is clearly insufficient to timely charge. Sixth, check
the tire At room temperature should be checked every month about tire pressure,
if less than the normal standard tire pressure should be promptly added.
Pressure is not too high or too low or affects driving safety. Check the tires
for cracks, there are security risks should be timely replacement tires. The
selection of tires should be made consistent with the model. Seventh, belt check
Usually when you start the engine or drive a vehicle belt hair ring, a long-term
situation is not checked belt adjustment caused by normal standards can be
adjusted. Another case is a test of aging, need to be replaced. Eighth, air
filter inspection Dirty air filter will cause poor engine, fuel consumption is
too large, damaged engines, while checking the air filter, if found less dust,
blocking light, can be used high-pressure air to blow out from the net, continue
to use. Too dirty air filter should be replaced. Ninth, spark plug inspection
Normal spark plug insulating ceramics is intact. No rupture leakage, spark plug
gap 0.8 +-0.0mm discharge, sparks is blue, stronger. If you find abnormal need
to adjust abnormal gap or replace the spark plug. Tenth, check the fuel filter
If it is found poor oil fuel filter should be checked for blockage, such
blockage should be replaced. Some car diagnostic tools can help you test your
car by yourself, such as: Autel Maxisys pro, MaxiDAS DS708 Tool, Autel Maxidiag
MD802 and so on. If you want to know some car maintenance information, please
click the below information: Better Website
Related Links